High-Pressure Electric Pump

Description

The eTensifer pump, the first-of-its-kind high-pressure electric pump system simply plugs into a wall outlet - no need for an air compressor like other high-pressure pumps on the market. The portable, lightweight (only 46 lb.) eTensifier will deliver hydraulic/liquid pressures to 36,500 psi with a smoother flow rate from zero to full pressure and a quiet electric motor.

 

The eTensifier represents new technology for the industry, introduced by three industry-leading names: patent-pending motors controls from Graco, proven hydraulic pumps from Sprague, and high-pressure components and customer service from HiP.

 

The eTensifier features SmartControl technology that allows for two operational modes: a traditional pressure knob for standard jobs and an industry-first pressure test mode that allows the user to set the desired pressure and walk away. In test mode, the controller will take the unit up to set pressure and then hold it to verify. The SmartControl technology also includes a cycle counter to assist in planning for routine maintenance.

 

Another first for the eTensifier is the ProConnect system to allow users to switch out the Sprague pump lower. This quick-connect system enables the operator to change out the pump lower with the loosening of a screw, facilitating a pump size change or maintenance replacement of the pump lower. The eTensifier pump can operate eight different pump sizes, allowing companies to reduce inventory requirements.

Specs

High Pressure Electric Power

  • Up to 36,500 psi
  • Needs no air compressor, plugs into wall outlet
  • Portable, weighs only 46 lb.

 

3 Industry Leaders Combined Expertise

  • Designed for Global conditions
  • Lightweight, portable unit
  • Integral pressure transducer

 

Smooth/Quiet Hydraulic/Liquid Intensifier

  • Smoother flow rate from zero to full pressure
  • Electric motor quieter than air powered pumps

 

ProConnect Lower

  • It is possible to interchange pump lowers within the same pressure transducer range, <10k psi, <30 k psi and >30 k psi
  • Users MUST make sure their entire pressure system is rated appropriately if changing the capability of pump, including, but not limited to, the burst disk and manifold

 

Smart Control

  • Pressure knob feature for standard jobs
  • Pressure test mode - set it and forget it
  • Cycle counter for routine maintenance planning

 

ProConnect

  • First-of-its-kind quick change Sprague pump lower
  • Install a spare lower to finish your job
  • No more downtime in the middle of a job
Be the first to review this product
Add your review:
RELATED STORIES