Quick-Clean Centri-Sifter® Centrifugal Screener has Cantilevered Shaft
Description
A new Centri-Sifter® centrifugal screener model “GO” from Kason Corporation features a cantilevered shaft with two, externally-mounted bearings between the screening chamber and motor drive, allowing all internals to slide freely from the shaft end for cleaning, screen changes or inspection. Wide spacing between the bearings, a large diameter shaft and a flexible shaft coupling combine to prevent vibration, even at high speeds under heavy, imbalanced loads, according to the company.
The new screener is intended for food, dairy and pharmaceutical applications requiring thorough wash-down, as well as other applications involving frequent screen changes/inspections or runs of multiple materials where cross-contamination is of concern.
It is available with compliance to USDA, FDA, BISSC, 3-A and other US and European sanitary standards, with Nylon monofilament, woven wire, or wedgewire screen cylinders. Configurations are offered for continuous operation in-line with dilute-phase pneumatic conveying systems, as well as gravity-fed applications.
Opening a hinged door at the discharge end of the screening chamber allows a retainer plate, screen cylinder, and helical paddle/feed screw assembly to be removed in one minute, according to the company.
Dry or moist bulk solid material is gravity-fed into the feed inlet and redirected into the cylindrical sifting chamber by means of a feed screw. Rotating helical paddles within the chamber continuously propel the material against the screen, while the resultant, centrifugal force on the particles accelerates them through the apertures. In addition to sifting and scalping of dry bulk materials, the screener can break up soft agglomerates and/or dewater moist solids or slurries. Oversized particles and trash are ejected through the end of the screen cylinder into a discharge spout.
The new screener is intended for food, dairy and pharmaceutical applications requiring thorough wash-down, as well as other applications involving frequent screen changes/inspections or runs of multiple materials where cross-contamination is of concern.
It is available with compliance to USDA, FDA, BISSC, 3-A and other US and European sanitary standards, with Nylon monofilament, woven wire, or wedgewire screen cylinders. Configurations are offered for continuous operation in-line with dilute-phase pneumatic conveying systems, as well as gravity-fed applications.
Opening a hinged door at the discharge end of the screening chamber allows a retainer plate, screen cylinder, and helical paddle/feed screw assembly to be removed in one minute, according to the company.
Dry or moist bulk solid material is gravity-fed into the feed inlet and redirected into the cylindrical sifting chamber by means of a feed screw. Rotating helical paddles within the chamber continuously propel the material against the screen, while the resultant, centrifugal force on the particles accelerates them through the apertures. In addition to sifting and scalping of dry bulk materials, the screener can break up soft agglomerates and/or dewater moist solids or slurries. Oversized particles and trash are ejected through the end of the screen cylinder into a discharge spout.
Specs
* Dust-free, sanitary operation. Approved for use by USDA, FDA, BISSC, 3-A and other U.S. and European regulators * Quiet, vibration-free action * Quick screen change: 2 minutes or less * Easy clean-out * Double seal outboard bearings * Rapid sieving action * Heavy duty construction for continuous operation * Compact design * Low power requirements * Integral cleaning/ inspection door * Many sizes and single or twin models, including belt-driven units with motors ranging from 1hp (.75 kW) to 5hp (3.75 kW) and direct-driven units with motors ranging from1 hp (.75 kW) to 3 hp (2.25 kW)