Reduce Downtime and Save Costs with Dual Output Encoder

Description

The dual output feature also has the capability to supply two separate controllers from a single encoder. Since the connectors are mechanically parallel and electrically isolated, connecting to a second controller and routing the cable is straightforward. Now you can save the cost and space of a second encoder with a single installation.

The HS35 series encoder is a heavy-duty hollow shaft design with a rugged cast metal housing and dual preloaded bearings for robustness and reliability. Rotating shaft seals and a sealed connector give it NEMA 4, 13 and IP65 ratings. It can accommodate a variety of shafts bores, up to 1 inch in diameter, and has a compact installed package length of just over 2 inches. This makes the HS35 ideal for equipment with constrained axial encoder mounting space.

Specs

• Shaft Bore: 1.00",0.875",0.750",0.625",0.500". All are supplied with insulating sleeves. • Allowable Misalignment: 0.005" T.I.R.on mating shaft 0.75" from shaft end • Bore Runout: 0.001" T.I.R maximum • Starting Torque at 25°C: Through shaft version (SS) = 7 in-oz (max); Blind • shaft version (BS) = 4 in-oz (max) • Bearings: 52100 SAE High carbon steel • Shaft Material: 416 stainless steel • Bearing Housing: Die cast aluminum with protective finish • Cover: Die cast aluminum with protective finish • Bearing Life: 7.5 X 109 • revs (50,000 hrs at 2500 RPM) • Maximum RPM: 6,000 RPM (see Frequency Response below) • Moment of Inertia: 0.019 oz-in-sec2 • Weight: 18 oz typical
Be the first to review this product
Add your review: