Rotobend Wire Former to be Featured at FIN-X 07 Show
Description
Mid-Minnesota Wire is introducing the new RotoBend Wire Former at the Fin-X 07 Show, September 17-20 in Indianapolis.
The RotoBend was developed by Mid-Minnesota Wire to form prototype and short run wire hooks, forms and fixtures. The all steel, compact, table size unit bends and forms up to 3/8 ” (.375”) diameter round and square mild carbon steel, stainless steel, galvanized steel, copper, brass and aluminum. A built-in, wire cutter cuts wire to .192” diameter
The RotoBend sets up in less than five minutes and will produce up to 500 standard wire forms per hour. Four wire forming mandrels are included.
The RotoBend Wire Former is ideal for job shops, coaters, fabricators, foundries and manufacturers of wire form products and products using wire forms.
The RotoBend was developed by Mid-Minnesota Wire to form prototype and short run wire hooks, forms and fixtures. The all steel, compact, table size unit bends and forms up to 3/8 ” (.375”) diameter round and square mild carbon steel, stainless steel, galvanized steel, copper, brass and aluminum. A built-in, wire cutter cuts wire to .192” diameter
The RotoBend sets up in less than five minutes and will produce up to 500 standard wire forms per hour. Four wire forming mandrels are included.
The RotoBend Wire Former is ideal for job shops, coaters, fabricators, foundries and manufacturers of wire form products and products using wire forms.